Wholesale Mg Hs Original Parts - SAIC MG RX5 front door handle10172952 – Zhuomeng

Products information

Products knowledge

How to install the door handle？

1. First unlock the central control button.

2. Pry open the screw cover with a flat-head screwdriver (just behind the handle, pull up the handle with your left hand, pry with your right hand with a flat-head screwdriver), and remove the screw counterclockwise with a Phillips screwdriver.

3. Remove the screws inside the decorative shell of the handle with a flat-head screwdriver.

4. Remove the door decoration plate, pry up the door plate with a flat-head screwdriver, make it have a gap with a Phillips screwdriver, find the door decoration plate card, there are more than one, to pry off. Then push the screwdriver between the gantry and the clip and give it a hard push.

And then the door trim goes up, and there’s a glass inner strip above the door trim that’s stuck to the door trim and then hung to the door, and this action is to pull it out. Be careful not to break the horn line with too much force. If it’s not easy to get off, grab the underside of the door trim with both hands and shake it up and down.

5. Remove the door decoration plate and you will see 3 wires: an inner pull wire, a small horn wire and a door and window controller wire. First remove the line of the small horn. Observe the horn plug carefully, press the elastic buckle on the plug and pull it out downward. Next remove the inner pull cable.

OUR EXHIBITION

Good Feetback

Products catalog

Related products