Why can't the trunk hydraulic brace hold?
The inner sealing ring is aging for a long time. Automobile hydraulic support rod for gas and liquid as the working medium of an elastic element, by the pressure tube, piston, piston rod and a number of connecting parts, its internal filled with high pressure nitrogen, because the piston is provided with a through hole, the piston at both ends of the gas pressure is equal.
That means there's something wrong with the hydraulic rod. This kind of problem does not arise in the winter, but also in the summer. It is necessary to purchase the hydraulic rod in the trunk of the vehicle for replacement, and it can be used normally after replacement, otherwise it will have a certain impact on the use.
The reason why the hydraulic support rod of the trunk is not elastic is: the situation caused by the failure of the support rod of the car trunk. The solution is: if the trunk support rod of the car fails, go to the 4S shop or repair shop of the car in time to replace the support rod of the car, which can solve the problem that the support rod is not elastic.
t Sagitta trunk hydraulic rod cannot stand means that the trunk hydraulic rod is damaged, and the pressure leakage in the hydraulic cylinder causes pressure loss inside, so the hydraulic rod can not support the trunk, and two hydraulic rods can be replaced.
Hydraulic support rod, using the principle of hydraulic pressure, the hydraulic pressure will not be so smooth in cold weather, the motor is also slow, the window lift is slower than normal temperature, this is normal.
How to remove the trunk support rod?
The steps to remove the trunk support rod are as follows:
1. First, remove the spacer on the left side of the trunk. This spacer is usually held in place by three clasps, so a screwdriver is needed when removing it, carefully removing the clasps to avoid using too much force and causing damage.
2. Next, hold a small piece of plastic against the head of the screwdriver and rotate it so that the clip can be removed. At the same time, push the rod body part of the screwdriver against the top of the support rod and compress the gas rod slightly.
3. Push it sideways while compressing the gas rod. When a "kata" sound is heard, it means that the disassembly is successful.
It should be noted that violence should be avoided as much as possible during operation to avoid damaging the trunk or support rods. In case of disassembly difficulties, it is recommended to seek professional help.
What's the reason the trunk won't lock?
The reasons for the failure to lock the trunk of the car may be as follows: the closing limit rubber block is not suitable for the locking mechanism, the trunk control circuit is faulty, and the hydraulic support rod of the trunk is invalid. These reasons may lead to the trunk can not be locked, if encountered in this case, owners should pay attention to, do not blindly close the trunk, should go to the repair shop in time for inspection.
The locking mechanism of the trunk is driven by a motor driven pull rod and gear reduction mechanism, which works in the same way as the central door lock. When the trunk cannot be locked, we can first check whether the trunk lock has been reset. You can use the metal rod of a screwdriver to simulate a lock and press it sideways to see if it can be locked. If the lock fails, it indicates that there is no reset and you need to check the cause of the bit failure. If it can be locked, check the gap between the lock and the latch fixed on the bottom door frame. It may be that the gap is too small and the lock is not enough to hold the latch. Adjust the gap to solve the problem.
If the above methods can not solve the problem, it is recommended that the owners go to the repair shop in time for inspection to avoid greater losses.
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
