How do I open the bumper cover.
The method of opening the bumper cover mainly depends on the type of bumper and the specific design of the vehicle. Here are some common ways to open a bumper lid:
For the front bumper:
First, open the cover, find and remove the bumper screws and clips on the cover.
Use a 10cm wrench to remove screws and clips from the edge of the bumper near the left and right front wheels.
Next, remove the bottom clip and use the pointed screwdriver to lift the center of the clip and pull it out.
If there are screws, use the appropriate tool (such as a plum screw or a 10cm wrench) to remove them.
Slowly mix on the side with your hands. If you encounter difficulties, check if there are still screws left.
For the rear bumper:
Use a flat screwdriver to pry into the gap in the middle of the clip, making sure all screws and clips are removed.
Then, pull the two sides of the bumper apart.
Bumper covers for specific models:
For example, for the MG rear bumper, it is necessary to prepare the corresponding tools, such as word screwdriver, t-25 spline, etc.
Open the trunk cover, look closely at the rear taillight edges, remove the two small black covers, and be careful not to scratch the surface.
Remove the screws under the rear taillight, then remove the harness plug from the rear taillight.
Continue to remove the screws under the rear taillights, as well as the screws holding the rear bumper to the inner lining.
Finally, gently separate the rear bumper from the rear bumper guide with your hands.
Other methods:
For the opening of the small round cap, you can use a screwdriver to do not open, slightly buckle open, or use a tool such as the car key to pry open.
To sum up, the method of opening the bumper cover varies by model and specific location, and needs to be operated according to the specific design of the vehicle and the use of the right tools.
Can a cracked bumper be repaired
A cracked bumper can be repaired.
Of all the parts outside the car, the bumper is the most easily damaged, if the bumper is seriously deformed or broken after the impact, the owner must replace the bumper, if the bumper is deformed or not seriously cracked after a slight impact, there is a way to repair, so there is no need to replace.
First use a professional plastic welding torch, melt the plastic electrode and film surface by heating, to achieve melting and bonding, secondly, paint repair should be carried out after crack repair, and complete the final drying, and some large cracks may not be repaired, if it can be repaired in time it is difficult to ensure its buffering effect, at this time it is necessary to replace the new bumper.
Car bumpers are located in most of the front and rear areas of the car, are designed on the surface to prevent the impact of external damage on the vehicle's safety system, they have the ability to reduce driver and passenger injuries in high-speed crashes, and are increasingly designed for pedestrian protection, with front bumpers costing significantly more to maintain than rear bumpers. First, because the front bumper involves more auto parts, the rear bumper only involves the rear taillight, exhaust pipe, reserve door and other low-value parts, and second, because most models are low after high design, so the rear bumper has a certain advantage in height, the bumper is composed of the bumper shell, the internal anti-collision beam and the left and right energy absorption box of the anti-collision beam. All of these together with other components form a complete bumper, or safety system.
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.