Automobile oil level sensor.
The reasons for the sudden high and low of automobile oil level gauge may include design differences, sensor fault, connecting rod stuck, run-in period influence, impurities caused by shell stuck and so on.
Design differences: different car fuel gauge design line scheme is not the same, , which affects the accuracy of the fuel gauge to a certain extent. Some fuel gauges drop faster in the first half, slowly in the second half, and vice versa.
Sensor failure: If the fuel gauge on a new car plunges to zero, often means there is a problem with the sensor. For older cars, may be the sensor that needs to be cleaned or replaced.
Connecting rod stuck: oil gauge scale suddenly rises, usually because the connecting rod between the oil level sensor and the float is stuck, leads to the float can not float normally, so that the sensor signal is unchanged, the fuel gauge pointer is fixed in a certain position. At this time, need to remove the oil pump to deal with the stuck problem.
Impact of running-in period: During the running-in period of the new car, oil meter fluctuation is a normal phenomenon. , however, if an older car is in similar condition, is recommended for inspection and repair.
Impurities cause jamming: oil gauge pointer stuck shell may be due to the accumulation of dust and other impurities in the table. To solve this problem, remove impurities from the table.
The fuel gauge is an indispensable part of a car. it works with the fuel level indicator and the fuel level sensor. is used to show the amount of fuel in the fuel tank. , therefore, the stability of the fuel gauge pointer is directly related to the driver's judgment of the remaining fuel amount of the vehicle. timely understanding and solving the problem of the sudden rise and fall of the fuel gauge pointer is very important to ensure driving safety.
How to repair the car fuel level gauge
The repair of an automobile oil level meter mainly includes checking and replacing the relevant parts, as well as ensuring that the wiring is properly connected.
Check the line connection: First check the line from the oil level sensor to the electronic control unit (ECU) to ensure that there is no open circuit or virtual connection. Any wiring problems can cause the fuel gauge to display inaccurately or not at all.
Replace the oil level sensor: If the sliding resistance of the oil level sensor has poor contact or serious wear, you should consider replacing the oil level sensor. This can solve the problem of sensor output error signal.
Check and replace the meter: If the meter circuit is abnormal or the electrical components are aging, the entire meter may need to be replaced to fix the problem.
Remove the oil pump for inspection: If the tank is deformed or the support is abnormal, it may be necessary to remove the oil pump for inspection.
Use diagnostic instruments: If there are problems such as virtual connection, open circuit or short circuit inside the engine module, diagnostic instruments can be used to assist in judgment.
Fastening the wiring wire: Wiring harnesses on cars usually share a common wiring point, and if the wiring wire of the oil level sensor or oil pump wiring harness is loose, it may also lead to inaccurate oil level display. In this case, all bonding wires should be tightened to troubleshoot.
Through the above steps, we can effectively diagnose and solve the problem of inaccurate display of automobile oil level meter.
If you want to know more, keep reading the other articles on this site!
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
