Take out the window glitter on your online shopping. One for the front door, one for the back door. Four in all
The back of the window glitter can be glued by removing 3M glue
Back side of the front window
Nice nanomaterials, a little thin. If the rider adds the suggestion to buy stainless steel glitter
Nano medium column back, 3M glue, uncovered available
Take out the rear window glitter and match it. Observe how the window glitter fits, especially the radians and the two ends
The window glitter and the door fit nicely. When installing the two window doors, be sure to leave a certain gap, otherwise, when driving the door, it is easy to knock the glitter.
Window glitter another fitting point, although a little gap, but also fit can be
Taking out the nano-column for comparison, the fit is also acceptable
Take out a wet towel to wipe the upper window frame, wipe off the upper window dust
The B-pillar should also be wiped clean of dust
The narrow edges should also be wiped clean. After the wet rag is finished, dry it with a dry towel
Take out the complimentary adhesive. The adhesive can better make the 3M glue in the window glitter firmly stick to the car window
Adhesive a pungent smell, very unpleasant. After the adhesive wipe, be sure to quickly stick 3M glue. The adhesive won't work over time
Rip 3M glue. Start by fixing the two ends of the window glitter and then stick it a little bit along one end
The key point of the rear window glitter is the pasting of this arc, it must be fitted well
Open the door and curve it to minimize the error
The rear window light strip is pasted on the top, and the fit is still perfect
