Wiper arm Angle adjustment method.
1. If the wiper Angle is not good, loosen the screw at the root of the wiper arm and adjust it to the correct position. Screw in the screw and close the dust cap. If the Angle of the wiper head is not good, the scraper does not fit well with the windshield, resulting in areas that are not clean or can not be cleaned.
2, the car's wiper arm needs to adjust the position, first need to lift the car's wiper arm and then remove the wiper strip, the towel wrapped wiper arm, ready to adjust the Angle of the wrench can be the car's wiper arm root screw loose.
3, the wiper Angle adjustment method: there is an adjustment screw behind the chain drive shaft, tighten it clockwise with a screwdriver and loosen it counterclockwise. Check the chain tightness while adjusting the thread tightness. You can pull the chain by hand.
4, open the hood to loosen the left wiper screw, move it to the correct position to pinch the screw, and then power it will automatically return to the bottom, but it will reveal a piece. At this time, loosen the right wiper screw, push the left wiper to the hidden place, and then pinch the screw, cover the dust cover is done.
5, you can loosen the screw at the root of the wiper arm and adjust it to the correct position. The Angle adjustment of the car wiper is not difficult, but the action must be gentle. After all, the wiper is still relatively fragile, if the force is too strong it is easy to damage the wiper.
6, first of all, open the key to ON, open the wiper, let the wiper blade automatically return to the front windshield below, turn off the switch and the key. Remove the dust cover at the base of the wiper arm and loosen the screw using a corresponding wrench or socket.
Rear wiper arm removed
The steps to remove the rear wiper arm are as follows:
Prepare tools and materials: Make sure you have the proper tools (such as screwdrivers or pliers) and safety equipment (such as gloves).
Stand the wiper arm up at 90 degrees: First, stand the rear wiper arm of the car up at 90 degrees.
Remove the rear wiper: Hold the fixed wiper arm with one hand, and remove the rear wiper with a little force with the other hand. There is a bayonet on the rear wiper arm. Remove the bayonet and you can see a nut. Remove the nut with a tool. The rear wiper arm can be removed by gently pressing the arm with your hand. Be sure to pay attention to the Angle when installing.
Remove the rocker arm: If you need to replace the rear wiper, you first need to stand up the rear wiper arm of the car at 90 degrees, and then grasp the fixed wiper arm with one hand, and remove it with a little force with the other hand. It should be noted that this process requires careful handling so as not to damage the wiper arm or the surface of the car glass.
Install new wipers: If you plan to install new wipers, now is the time to do so. Slide the new wiper into the wiper arm until it locks into place. Make sure the new wiper is securely attached to the wiper arm and will not slip off during operation.
When removing the wipers, you need to pay attention to the following points: ensure that the car has been turned off, and unplug the power to prevent short circuit or other safety hazards.
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
