How often should the front brake discs be replaced?
60,000 to 100,000 kilometers
The replacement cycle of the front brake disc is usually recommended between 60,000 and 100,000 km driven, depending on a number of factors, including driving habits, driving environment, and the quality and wear of the brake disc. Frequent use of brakes in urban areas and mountainous areas may lead to accelerated wear of brake discs, requiring shorter replacement cycles; On the highway, fewer brakes are used and the replacement cycle can be extended. In addition, if the brake disc warning light comes on or there is a deep groove in the brake disc, the thickness is reduced by more than 3 mm, the brake disc may also need to be replaced in advance. Therefore, it is recommended that the owner regularly check the wear of the brake disc, and replace it in time according to the actual situation to ensure driving safety.
Car front brake disc broken symptoms, car front brake disc broken can repair?
The brake system is a very critical part of the car, no matter how fast the car runs, the key is to stop the car at the critical time. In the brake system, the brake disc is damaged, which has a great impact on the braking effect. So what should I do if the car's front brake disc is broken?
Brake disc damage will mainly be rust and excessive wear of these two aspects, in specific cases, there will be different symptoms.
1. Brake trembling
Due to the wear or uneven wear of the brake disc, the flatness of the surface of the brake disc will be out of alignment, and the car will tremble when braking, especially in some old cars. If this is the case, the brake disc should be checked in time, and it is recommended to choose the "disc" or replace the brake disc according to the situation.
2. Abnormal sound when braking
If you step on the brake, a sharp metal friction sound, it is likely because the brake disc rust, brake pad thinning, brake pad quality or brake pad in the foreign body caused by, it is best to go to the maintenance point to check!
3. Braking deviation
If the owner of the steering wheel is obviously skewed to one side when stepping on the brake, the main reason is that the brake pad is worn off or the brake pump has a problem, so once this situation occurs, it is necessary to go to the repair shop immediately to check the front brake disc swing amount.
4. Rebound when you step on the brake
If the brake pedal rebounds when the brake is pressed, this is mostly caused by the uneven surface of the brake disc, brake pad, and steel ring deformation.
What failure will occur when the car's front brake disc is broken, the above has been introduced to you very clearly, I hope you pay more attention when you usually drive, after all, the braking effect is good, and it has a great impact on everyone's driving safety.
Are the front brake discs the same as the rear brake discs
unlikeness
The front brake disc is different from the rear brake disc.
The main differences between front and rear brake discs are size, braking efficiency, and wear rate. The front wheel brake disc is usually larger than the rear wheel brake disc, because when the car brakes, the center of gravity of the vehicle will shift significantly forward, resulting in a sharp increase in the pressure on the front wheels. Therefore, the front wheel brake disc needs a larger size to cope with this pressure, which can produce more friction during braking and improve the braking effect. Since the engine of most cars is installed in the front, making the front part of the heavier. When braking, a heavier front means more inertia, so the front wheels need more friction to provide sufficient braking force, and the brake discs are therefore larger. In addition, the brake disc and brake pads of the front wheel are large, indicating that the friction generated during the entire braking process is large, which indicates that the braking effect is better than the rear wheel. This design allows the front brake disc to wear out much faster than the rear brake disc.
In summary, there are obvious differences in the design of the front brake disc and the rear brake disc, mainly to adapt to the different pressure distribution and braking force requirements of different parts of the vehicle during the braking process.
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
