It is recommended that you use the brake disc, caliper and brake pad of the brake series matched with your car. The best time to replace the brake pad is that the thickness of the brake pad of the disc brake can be checked by stepping on the brake plate, while the thickness of the brake pad on the brake shoe of the drum brake must be checked by pulling the brake shoe out of the brake.
The manufacturer stipulates that the thickness of the brake pads on both disc brakes and drum brakes shall not be less than 1.2mm, because all actual measurements show that the brake pads wear and peel faster before or after 1.2mm. Therefore, the owner should check and replace the brake pads on the brake at this time or before.
For ordinary vehicles, under normal driving conditions, the service life of the brake pad of the front brake is 30000-50000 km, and the service life of the brake pad of the rear brake is 120000-150000 km.
When installing a new brake pad, the inside and outside shall be distinguished, and the friction surface of the brake pad shall face the brake disc to make the disc fit properly. Install the accessories and fasten the clamp body. Before tightening the tong body, use a tool (or special tool) to push the plug on the Tong back to facilitate the installation of the Tong in place. If the brake pad on the drum brake needs to be replaced, it is recommended to go to a professional maintenance factory for professional operation to avoid errors.
The brake shoe, commonly known as the brake pad, is a consumable and will gradually wear out in use. When it is worn to the limit position, it must be replaced, otherwise it will reduce the braking effect and even cause safety accidents. The brake shoe is related to life safety and must be treated with caution.
