Saic MAXUS G10 middle door how to dismantle?
The steps to remove the SAIC MAXUS G10 middle door include the following:
1. Locate the small hole next to the door handle and gently insert and press the small screwdriver to pull out the door handle.
2. Then, using a plastic clip or similar tool, insert it carefully along the edge of the door panel and gently push it outward to release all the clips.
3. After confirming that the door is open and the window is fully raised, search the inside of the door for the position of the buckle. This position may be covered by a small cover plate. In this case, you can carefully pry open the cover plate with a small flat head screwdriver or a plastic switch knife.
4. After removing the cover, you will be able to see the screws or fixed interfaces attached to the inner buckle of the center door. Tools such as screwdrivers, wrenches, or Allen wrenches can be used to remove screws or loosen the connection interfaces according to the specific design.
5. The inner buckle of the middle door of some models may need to be rotated in a specific direction before it can be smoothly removed.
6. When removing the interior panel of the middle door, first find the small plastic panel covered by the screw mounting point of the inner door buckle, and remove it, and then remove the screw.
7. Next, find a flat or steel plate with higher hardness, insert it from the gap between the door core plate and the door metal, move it to the position with a buckle, and pry it up to separate. Pry up all latches in turn in this manner.
8. When removing the door decoration panel, use a flat-head screwdriver to pry up the door panel, and then use a Phillips screwdriver to create a gap. Then find the clamps on the door panels and pry them off one by one. Insert the screwdriver between the door frame and the clip and force it to pry, then lift the door trim up and pull out the upper glass inner bar.
9. When you remove the door panel, you will see three wires. First remove the cord from the small speaker, press the elastic buckle on the plug and pull out the plug. Then remove the pull cable of the inner handle by holding it close to the fixed point of the pull cable and pushing the damaged pull with your thumb until the pull cable pops out. Finally push out the whole door and window controller, also press the elastic buckle on the plug and pull out the plug.
Note the following items during operation:
1. All removed screws should be stored properly.
2. Take special care when removing the door trim plate to avoid damaging the clip.
3. Be careful not to break the wire during disassembly.
4. Take extra care when removing the horn to avoid damage.
5. If you are unsure about the operation or encounter difficulties, it is recommended to consult a professional auto maintenance technician or contact the official customer service of Datong Auto for accurate guidance.
If you want to know more, keep reading the other articles on this site!
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
