Are the handbrake pads the same as the brake pads?
The handbrake pads are not the same as the brake pads. Although both handbrake pads and brake pads belong to the brake system, they are responsible for different functions and principles.
hand brake , also known as hand brake, is mainly connected with the brake block by steel wire, through the friction of the rear wheel to achieve a short stop or prevent slipping. Its main purpose is to provide auxiliary braking when the vehicle is stationary, especially on ramps to prevent the vehicle from slipping due to wheel rolling. The use of the handbrake is relatively simple, just pull up the handbrake lever, which is suitable for short time parking, such as waiting for a red light or stopping on a ramp. However, using the handbrake for a long time may cause the brake pads to rub against the brake disc, causing the brake pads to wear and even burn the brake pads.
brake pad , also known as foot brake pad, is the main bearer of service brake. It holds the brake pads tightly through calipers to generate enough braking force to slow down or stop. The braking force of the foot brake is much greater than that of the hand brake, and the original design is to meet the strong braking force required for emergency stopping.
In summary, although both handbrake pads and brake pads are used for braking purposes, they have significant differences in principle, function and application scenarios.
How often should the handbrake be changed?
The replacement cycle of the handbrake is usually checked every 5000 km and replaced if necessary. The handbrake disc, also known as the auxiliary brake, is connected to the rear brake shoe by a steel wire to realize the braking function of the vehicle. Brake pads (brake pads) are the key safety parts in the automotive brake system, and the degree of wear directly affects the braking effect. Therefore, it is very important to regularly check the thickness of the handbrake, the wear on both sides and the return situation. If the handbrake is found to be seriously worn, it should be replaced in time to avoid safety hazards caused by handbrake failure.
In general, the replacement cycle of the handbrake can refer to the following points:
driving habits : If the driving habits are good and the vehicle is properly maintained, the handbrake can generally be replaced after driving 50,000-60,000 kilometers.
driving mode : If the driving mode of sudden braking or frequent heavy braking is often used, especially for novice drivers, it is recommended to replace the handbrake tablet 20,000-30,000 kilometers in advance.
inspection frequency : It is recommended to check the wear of the handbrake piece every 5000 kilometers to ensure that its thickness and wear degree are within the safe range.
The correct installation and timely replacement of the handbrake is essential to the safety of the vehicle. If the handbrake is improperly installed or seriously worn, it may cause the handbrake to fail, so that the vehicle cannot be effectively stopped, resulting in safety hazards. Therefore, regular inspection and timely replacement of the handbrake is an important measure to ensure driving safety.
Where is the handbrake?
The inside of the rear brake disc or brake drum
The handbrake disc is usually located on the inside of the rear brake disc or brake drum.
The handbrake plate is the key component of the handbrake system to achieve braking. They tighten the handbrake line through the operation of the handbrake pull rod, so that the handbrake plate and the brake disc or brake drum are in close contact, generating friction, so as to achieve braking. The function of the handbrake is achieved through brake pads, which are mounted on the brake drum or brake disc of the vehicle. The handbrake mechanism is controlled by the pull wire, when the handbrake is operated, the pull wire will pull the brake pad to make it contact with the brake disc or brake drum, resulting in friction to stop the vehicle. The position and installation method of the handbrake will vary depending on the model and the type of handbrake (such as manipulator brake, electronic handbrake, etc.), but the basic principle is the same, which is to achieve the parking brake of the vehicle through friction.
If you want to know more, keep reading the other articles on this site!
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
