How to remove the front bumper of SAIC MAXUS g10?
Prepare tools One Phillips screw with a diameter of 6mm. Use each of the auxiliary warping plates to remove the 7 mm fender and fender expansion screws from the core fasteners. Parking operation Find an environment with sufficient operating space on both sides of the front and in front of the car to park the vehicle Open the front cabin cover. Remove the upper fastener. Remove the fastener fastening the engine intake pipe as shown in the figure. If necessary, use special tools to help remove the fastener. Remove the four M6 large round crosshead fixed screws at the top of the upper middle net of the bumper skin. Remove the fixed fasteners on the left and right ends of the top center net at the upper part of the bumper skin. Remove the left and right lateral fasteners. Find the hidden tapping screws on the outside of the left and right ends of the bumper skin and remove them with a Phillips screwdriver. Push the front wheel inwards to remove the two retaining clips at the left and right wheel arcs of the bumper skin. Remove the bottom fasteners. Lay a carton board on the ground. Remove the row of fasteners at the bottom of the bumper skin. Lift down the bumper and prepare two cartons or foam boxes about 30cm high in advance. The seams of the left and right ends of the bumper skin and the front fender are hidden buckle structures directly open to the outside. Handle the wiring harness plug headlight cleaning nozzle water pipe for quick loose connection Pinch the release clip and pull out the temporary fixed water pipe head higher than the level of the water bottle in the front wash window. Press the release button to unplug the harness plugs left and right behind the front ranging radar. Press the release button to pull out the wiring harness plugs left and right behind the front fog lamp. High-powered models have a place in the middle of the bumper behind the net where the wiring harness of the 360 surround image front camera must be unplugged. The installation can be performed in reverse phase sequence.
How to solve the front bar support failure of MAXUS g10?
The solutions to the front bar support faults of MAXUS G10 mainly include replacing the support and adjusting the installation of the support.
replacement support : If the front bar support fails, the first consideration is to replace the support. This may be because the support is too long, the design is not reasonable, or the quality of the problem. The way to solve this problem is to replace the corresponding bracket, you can choose a brand special bracket or 3M bracket, you can also consider using a suction cup bracket, but it needs to be noted that the suction cup bracket is easy to fall off, there are certain safety risks. Choose the right bracket according to your needs, if the bracket is too long, you can consider replacing a shorter bracket to avoid unstable situations. At the same time, when choosing the bracket, pay attention to whether the design is reasonable to ensure its fastness .
Adjust support installation : If there is no problem with the support itself, but the problem caused by improper installation, it can be solved by adjusting the installation of the support. This may involve adjusting the connection of the bracket to the rest of the car, ensuring that all screws and clasp are properly installed and nothing is missed. In particular, pay attention to the removal and installation of screws at the junction of the bumper and the leaf plate, which is a key step in replacing the front bumper bracket. During the disassembly process, someone needs to help distinguish the bumper so that it is easier to operate. The whole process may take about 10 more minutes, but care is needed to avoid damaging other parts .
In summary, the solution to the failure of the MAXUS G10 front bar bracket includes replacing a better quality bracket and ensuring proper installation. During operation, pay attention to safety to avoid potential security risks caused by improper operation.
If you want to know more, keep reading the other articles on this site!
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
