MAXUS G10 door lift switch fault solution.
The solution to the door lift switch failure mainly includes resetting the window lift system, removing the dirt in the glass guide slot, and directly replacing the glass lift switch.
Reset the window lift system : First, turn on the ignition, lift with it and hold it until the glass is at the top for more than 3 seconds. Then release the switch and immediately press and hold until the glass drops to the bottom and continues to hold for more than 3 seconds. Repeat the lifting action once again to complete the initialization procedure, and the window lifting function may be restored.
Remove dirt in glass guide trough : Put chopsticks wrapped in wet towel into the glass guide trough, according to the width of the guide trough appropriate to adjust the layer of chopsticks wrapped in towel, so that the thickness is moderate. Push up and down in the guide groove to clean up, and keep taking down the towel to clean the dirt washed down, until the dirt is no longer clean.
Directly replace the glass lifter switch : The window lifter switch is one of the most commonly used switches in cars. If the switch is damaged, it can be replaced at home. This method has a low cost, only tens of yuan, and the operation is relatively simple, as long as there is a certain hands-on ability, it can be replaced in about half an hour.
These methods can help solve the problem of door lifting switch failure. If the above methods do not solve the problem, you may need to consider more professional repair or replacement parts .
Why does the MAXUS G10 door lift switch light not work?
The problem that the door lifting and switching lights do not work may be caused by a variety of reasons, including power supply problems, switch faults, wiring problems, and software problems.
First of all, checking the power supply is a necessary step. If there is a power supply, then the regulator itself may be faulty; If there is no power supply, there may be a problem with the switch or line. In addition, it is also important to check that the light switch has been set to the on state, because if the switch is not set correctly, the light will naturally not light up. If the light is still not on, it may be the interface behind the dashboard is loose, then you need professional repair .
For MAXUS G10 models, if you experience problems with glass lifting, child lock switch backlight failure, it is usually not necessary to replace the left front door glass lifter switch or door controller. The problem may be at the software level and require a corresponding software refresh to fix it. Specific refreshing methods include opening the diagnostic function, entering the special function menu, selecting the control unit software configuration, and entering 42/09 in the diagnostic address bar (if 42 is displayed in the networking diagram, enter 42; Otherwise enter 09), accept the setting and follow the prompts to finish refreshing the new version of the door controller ZDC online at 23.
To sum up, the problem that the door lifting switch light is not on needs to be diagnosed and handled according to the specific situation, which may involve power check, switch setting adjustment, software refresh, fuse check and other aspects. If the fault cannot be solved by yourself, contact professional maintenance personnel for check and repair .
If you want to know more, keep reading the other articles on this site!
Please call us if you need such products.
Zhuo Meng Shanghai Auto Co., Ltd. is committed to selling MG&MAUXS auto parts welcome to buy.
