Renewable Design for Mg3 Spare Parts Manufacture - SAIC MAXUS G10 and V80 Front Wiper Motor – Zhuomeng

Products Information

MAXUS G10 Front Wiper Motor C00017987

Product knowledge

The wiper motor is driven by the motor. Through the connecting rod mechanism, the rotary motion of the motor is changed into the reciprocating motion of the wiper arm, so as to realize the wiper action. Generally, the motor can be switched on to make the wiper work.

The windshield wiper of the car is driven by the windshield wiper motor, and the potentiometer is used to control the motor speed of several gears.

At the rear end of the wiper motor there is a small gear transmission enclosed in the same housing to reduce the output speed to the required speed. This device is colloquially known as the wiper drive Assembly. The output shaft of the assembly is connected with the mechanical device at the end of the wiper, and the reciprocating swing of the wiper is realized through the fork drive and spring return.

wiper motor for SAIC MAXUS V80 C0001

quality standard

The windshield wiper must meet the following requirements: remove water and snow; Remove dirt; Can work at high temperature (80 degrees Celsius) and low temperature (minus 30 degrees Celsius); Acid, alkali, salt and ozone resistance; Frequency requirements: there should be more than two kinds of speed, one is more than 45 times /rain, the other is 10 ~ 55 times /min. And the difference between high speed and low speed should be greater than 15 times /min; Must have automatic stop function; Service life should be more than 1.5 million cycles; Short circuit time is more than 15 min.

Customer evaluation