How does a knuckle work?
The working principle of the steering knuckle is to transfer and bear the load on the front of the car, support and drive the front wheel to rotate around the kingpin and make the car turn. Steering knuckle, also known as "ram's horn", is one of the important parts of the automobile steering bridge, which can make the car run stably and transfer the direction of travel sensitively. The adjustment method of steering tie rod is as follows:
1, from the direction of the machine around the bar adjustment, that is to say, to tighten while loosening, so that the steering wheel will be adjusted;
2, if the steering wheel is just a spline teeth, you can also remove the steering wheel, turn a tooth Angle can be;
3, the left and right steering Angle is not the same, if done after four wheel positioning, the steering wheel Angle will be very small, from the direction machine left and right pull rod to adjust, will not have a big impact on the steering Angle.
The function of the steering knuckle is to transfer and bear the load on the front of the car, support and drive the front wheel to rotate around the kingpin and make the car turn. The wheels and brakes are mounted on the knuckle, which rotates around the pin when steering. Steering knuckle, also known as "ram's horn", is one of the important parts of the automobile steering bridge, which can make the car run stably and transfer the direction of travel sensitively. The steps of disassembly and assembly of steering tie rod are as follows:
1. Remove the dust jacket of the car pull rod: in order to prevent the water in the car direction machine, the pull rod is equipped with a dust jacket, and the dust jacket is separated from the direction machine with pliers and opening;
2. Remove the connecting screws of the tie rod and the turning knuckle: remove the screws connecting the tie rod and the steering knuckle with the No.16 wrench. If there is no special tool, you can use the hammer to knock the connecting parts to separate the tie rod and the steering knuckle;
3, pull rod and direction machine connection ball head: some cars this ball head has a slot, you can use an adjustable wrench stuck in the slot to screw down, some cars are circular design, then it is necessary to use pipe pliers to remove the ball head, the ball head loose, you can take down the rod;
4, install the new pull rod: compare the pull rod, confirm the same accessories, can be assembled, first put one end of the pull rod mounted on the direction machine, but also to the direction machine lock riveting, and then install the screws connected with the steering knuckle;
5. Tighten the dust jacket: although this is a very simple operation, it has a great effect. If this place is not handled well, the water in the direction machine will lead to abnormal sound in the direction.
6, do four wheel positioning: after the replacement of the tie rod, we must do four wheel positioning, the data adjustment in the normal range, otherwise the front bundle is wrong, resulting in gnawing.